Uher SG 560 ‘Royal’

395$Can
1
Fully tested good working

Seller Information

El Camino
(0)

Uher SG 560 Reel to Reel Recorder in very good condition. These are quite rare in North America and this model features adjustable voltage which is set for North American. It's a great sounding tape deck that will rival many mid to higher end Japanese machines. All the controls are listed in German so it takes a little getting used to. Missing the knob for the microphone input on the bottom left. It has a carrying handle which doubles as a mounting base when clicked into position and has a dust cover in decent condition. Based on how this sounds, it's a superb machine for $400 and I have a lot of other tape decks to compare with so that is an informed opinion. 5 pin DIN connections to hook up to your system. Can provide a suitable cable to your specification if needed at an extra charge. I might be a bit hesitant to send it out in case the buyer cares about what happens to the dust cover. $350 for local pickup. EMT, cash or PayPal using friends and family payments are the options.

Technical Details

Uher
SG 560 'Royal'
Mid High Fidelity
Consumer
Solid State
Germany
1/4 Rec/PB
1 7/8, 3 3/4, 7 1/2
7"
3
Permalloy
Stereo
3
No
110-120v, 220-240v
7 / 10
7 / 10

Additional Details

Description

Surpassing the requirements of German Hi-Fi standard DIN 45 500, the 560 Royal was a stereo tape recorder with interchangeable tape heads and a myriad of trick recording facilities. An inbuilt 10 watt per channel amplifier drove twin internal speakers and the recorder featured four tape speeds, from 15/16 ips to 7½ ips. Where most tape recorders have a power switch, this one incorporated it into the speed selector switch. German efficiency?
The ‘Tape Tension Comparator’, featured on this recorder, was developed by Uher to maintain constant tape movement. It utilized two sensing levers either side of the tape slot which matched the tape tension with the constant tension of a coiled spring, thus assuring the least tape damage possible even when using reels of differing sizes.

The fact that this great sounding tape recorder was capable of 20Hz – 20kHz at 7½ ips, it seems strange that they chose to include an amplifier and speakers which at that time was old-school.
Who needs a high-quality tape recorder at the beach playing through low-grade speakers?

Additional Info

Hum and noise: 56dB (quarter-track) and 58dB (half-track) at 7½ ips / Crosstalk: better than 45 dB stereo, 60 dB mono / Bias frequency: 100 kHz / Erase ratio: better than 72 dB / Audio output power: 10 watts continuous at 4 ohms / Inputs: mic: 0.12 mV- 70 mV / 2 kohms tuner (stereo): 1.2 mV- 110 mV / 47 kohms phono 1: 40 mV – 2.8 V / 1.2 Mohms phono 2: 200 mV – 18 V / 50 Kohms / Outputs: monitor: 750 mV / 15kohms line: 750 mV / 15kohms / Speaker(s): two internal speakers

Half or quarter-track stereo (interchangeable, plug-in heads)

Servicing the 560

It’s not immediately obvious how to get to the inside of this tape recorder. The service manual is in English German and French and is a bit vague but says the following…

1.0 Swinging the recorder from its case and removing depositor. (depositor means the front cover)

For the purpose of carrying out service work, the unit is swung out from the case or the front panel removed.

(a) Swinging out the recorder:
Unscrew the two large fixing screws. Now swing out the unit from the case and support it or place it an one side.

(b) Removing the front panel:
Pull off front sound-head cap and all control knobs. Unscrew the eight fixing
screws of the depositor and remove front panel . (sound-head cap means head covers)

Trying this myself, it appears that you need to do the front cover first and remove all the knobs etc. then you remove the setscrews on the sides (not the ones that hold the carrying handle)
now you can pull the plastic covers apart and they do need some gentle persuasion. They only spread apart so much, but enough to remove the chassis.
Seems like a pretty poor design for German engineering. But a nice sounding tape recorder.